This site uses cookies for functional purposes. To continue please read and agree to our Data Privacy.

By closing this message, you consent to our use of cookies on this device.

  1. David Petter
  2. PLCnext Technology & PLCnext Controls
  3. Thursday, 08 March 2018
  4.  Subscribe via email

So, this is not a question, this is a tutorial on how to compile and use OpenCV on the AXC F 2152. I wanted to upload this a while back, but when I had written down almost everything, I encountered some issues with my PLC. All was solved, all is well, and now I am ready to share this with you.

 

It might very well be that there are certain mistakes or wrong statements written in this tutorial, I am by no means an expert on this platform, and I am still learning. I am more than willing to change the document in case you guys think there are mistakes. The attachment of this message consists of a zipped file, including a .html and a .pdf file. Pick your flavor.

 

 

Knowledge not shared is knowledge wasted.
Regards,
David.

Attachments (1)
Eduard PLCnext Team Accepted Answer Pending Moderation
0
Votes
Undo

Good Morning David,

thanks for your tutorial and the detailed description!

I'll check it in the next days and give you a feedback as soon as possible.

Best Regards
Eduard


Phoenix Contact Electronics Headquarter - Support Center

Eduard PLCnext Team Accepted Answer Pending Moderation
0
Votes
Undo

Good Morning David,

thanks for your superb and detailed description for compiling of FFmpeg library and OpenCV project and using it on the AXC F 2152!  The tutorial is very easy to view and can be reproduced well. I would like to copmlete it with additional references and general information about FFmpeg/OpenCV project and publish it as an official tutorial in the community, if nothing prevents. Please give me a short feedback if you agree.

Thanks and Best Regards
Eduard


Phoenix Contact Electronics Headquarter - Support Center

David Petter Accepted Answer Pending Moderation
0
Votes
Undo

Be my guest. Would you like the .docx file for editing purposes? If so, please PM your mail address if that is possible on this forum, I will mail you the file.

Regards,
David.

  • Page :
  • 1


There are no replies made for this post yet.
However, you are not allowed to reply to this post.

We have 59 guests and 2 members online