Creating users (combined safety) For more information on the user management, refer to the general topic Creating users . Additional safety user roles SafetyEngineer There is a special user role for downloading safety programs: the SafetyEngineer. Note: You must always assign the SafetyEngineer user… Read More
Checking the device (combined safety) Log in to the WBM. Return to topicHow do I get to the WBM again? Click here for more information… Establishing a connection to the Web-based Management (WBM): Open a web browser on your computer. In the address field,… Read More
Checking the integrity state (combined safety) If the Security Profile is activated, an integrity state check is performed after each boot and log-in to the WBM. The integrity state is displayed in the WBM in the page header line right to the Security Profile state field. Note:… Read More
Configuring PLCnext Engineer (combined safety) Write and Start Commands To include the safety-related project when downloading (writing and starting) a project, you must activate the respective checkboxes in the options menu. To do this, proceed as follows: In PLCnext Engineer, open the options menu: Extras → Options… Open to Online… Read More
Security logging (combined safety) To control specific notifications when starting the safety controller, set the filter function “Sender” to “SPLC”. Then you will see the corresponding notifications, example see screenshot below. After starting the safety controller, check the consistency of the safe project and the… Read More
